Ferrule pre-assembly machine
Presses the ferrule onto the tube end before the fitting is assembled. Replaces hand seating, so the seating depth is set by the machine rather than by operator feel.
One line covering the tube preparation stage: pre-assemble the ferrule, form the tube end, bend, cut and deburr. Machines are compatible with carbon steel, stainless steel, copper and aluminium tube.
Presses the ferrule onto the tube end before the fitting is assembled. Replaces hand seating, so the seating depth is set by the machine rather than by operator feel.
Reshapes the tube end by radial extrusion under hydraulic pressure: flaring, expanding, necking and beading on one unit with interchangeable clamping dies and ejector tools.
Stores multi-angle parameter sets and repeats them, with a deformation-prevention structure and foot control. Aimed at small and mid-size tube workshops that switch between runs.
Removes burrs, flash, sharp edges, weld slag and oxide from the inner wall, outer wall and end face after cutting, welding or stamping, so the surface is consistent before assembly.
Cold saw cutting of tube to length with a burr-free cut face, the first step of the tube preparation chain.
Specification pending the printed catalogue.
Winds thread sealing tape to a consistent tension and overlap, replacing manual winding in accessory workshops.
Specification pending the printed catalogue.
Spinning forming of tube ends where the wall is thinned and flared by roller action rather than by press.
Specification pending the printed catalogue.
Band saw cutting for bar and tube where a portable or floor unit is needed before machining.
Specification pending the printed catalogue.